MyRadAgent
HomeTools › Fleischner Society pulmonary nodule follow-up calculator

Fleischner Society pulmonary nodule follow-up calculator

Enter the nodule characteristics to get the Fleischner Society 2017 follow-up recommendation for an incidentally detected pulmonary nodule. The complete decision table is reproduced below the calculator, so you can check the branch you landed on.

Nodule type
Size (mean of long and short axis, mm)
Number
Patient risk
Adjust the inputs to see the recommendation.

Solid nodules — full decision table

SizeSolitary, low riskSolitary, high risk Multiple, low riskMultiple, high risk
<6 mmNo routine follow-upOptional CT at 12 monthsNo routine follow-upOptional CT at 12 months
6-8 mmCT at 6-12 mo, then consider CT at 18-24 moCT at 6-12 mo, then CT at 18-24 moCT at 3-6 mo, then consider CT at 18-24 moCT at 3-6 mo, then consider CT at 18-24 mo
>8 mmConsider CT at 3 mo, PET/CT, or tissue samplingConsider CT at 3 mo, PET/CT, or tissue samplingCT at 3-6 mo, then consider CT at 18-24 moCT at 3-6 mo, then consider CT at 18-24 mo

Subsolid nodules — full decision table

TypeSizeSolitaryMultiple
Ground-glass<6 mmNo routine follow-upCT at 3-6 mo; if stable, consider CT at 2 and 4 years
Ground-glass≥6 mmCT at 6-12 mo to confirm persistence, then CT every 2 years until 5 yearsCT at 3-6 mo; management based on the most suspicious nodule
Part-solid<6 mmNo routine follow-upCT at 3-6 mo; if stable, consider CT at 2 and 4 years
Part-solid≥6 mmCT at 3-6 mo to confirm persistence. Solid component <6 mm: annual CT for 5 years. Solid component ≥6 mm: consider PET/CT, biopsy, or resectionCT at 3-6 mo; management based on the most suspicious nodule

When Fleischner does not apply

What counts as high risk

High risk means an elevated probability of malignancy — heavy smoking history, older age, upper-lobe location, spiculated margin, emphysema or fibrosis, or a family history of lung cancer. Fleischner leaves the judgment to the reader rather than fixing a numeric threshold.

Measuring the nodule

Fleischner 2017 uses the average of the long-axis and short-axis diameters, measured on the same transverse, coronal or sagittal section, rounded to the nearest millimetre. For part-solid nodules, measure the solid component the same way. The size thresholds refer to this mean diameter, not the single longest dimension.

Related

Source. MacMahon H, et al. Radiology 2017;284(1):228-243. View on PubMed
This is a reference implementation of a published guideline, for use by qualified clinicians. It does not account for patient-specific factors and is not a substitute for clinical judgment or a formal radiology consultation. See our full disclaimer.